Wood slab table is plain, flat and provide maximum workspace and unobstructed. Wooden slab tables are also the simplest form of table to make and install. The slab consists of a large single piece of wood, cut to fit, placed on top and fixed to the table. Wooden slab tables can be formed from cheap materials like plywood, expensive hardwood, or even an old door. The manufacturing process and installation of your own wood slab desk requires only some tools to work the basic wood, and some carpentry skill. Place the 4 by 8, 3/4-inch foot of birch plywood sheet on a flat work surface. Use your tape measure and a pencil to mark the sheet of plywood with the dimensions that are required.
To determine the size of your best wood slab table should be, use your tape measure to record the length and width of your desktop frame. And then add 2 inches to each side of the desktop frame to calculate the size of your target desk. For example, if the desktop frame measures 36 by 60 inches, the desktop should measure around 40 by 64 inches. Use a hand press to attach a straight 1-by-4-inch plate to the top of the plywood sheet, for use as a guide when cutting the length of your desk. Place the board parallel to your pencil marks, so that when placed against it, your circular saw blade touches the dead pencil marks on. Then, hold the board down firmly and use your circular saw to make the cut. Repeat the same process to cut the desktop width.
Use your miter box and hand saw to cut a 45-degree angle at one end of a 1-inch square piece of wood trim. Place the edging against one of the long sides of your solid wood slab table, so that the shorter end of the miter edge lines up with the desk, and the projects edge longer out and beyond the corner. Mark the other end of the molding 1 inch, where the opposite end of the table falls. Use your miter box and hand saw to cut a 45 degree angle at this end, so, use your pencil mark as the shorter end of the angle. Repeat this process to create borders on each side of the desktop. Apply the wood glue to the inside edge of the desktop molding. Use clamps to hold the position adjustment along the edge of the table.