Instructions to Build a Loft Bed

0

Build a loft bed are a quick way to increase the space in all bedrooms. Small rooms – like dorms – can be especially benefited because there is an area for a desk under the bed. Cot beds are better for teens because the risk of falling out of bed is significantly lower than with younger children. Building a loft bed is surprisingly light and can be filled in in a couple of hours. You must have basic knowledge of tools; know how to read a tape measure.

Instructions

How to build a loft bed with desk with measure and cut three 2-by-6 discs to 78 inches. Measure and cut the last two 2-of-6s in four boards of 37 inches. Create the frame of the bed by placing two of the longer boards parallel to each other. Drill through on the outside of the longer boards at the ends of the shorter boards with three to four screws in each corner. Measure and cut plywood to the dimensions of the frame just built (40 by 78 inches). Attach plywood to the bottom of the frame with screws spaced every 12 to 18 inches. This creates a mattress box to seat in with a 1 inch space around the bed linens.

READ ALSO :   Simple Ways of Diy Shaker Cabinet Doors

Place the last 78-inch board on its side and place the remaining two 37-inch discs at each end. Line the discs in the same way as when building the frame and use screws to attach to each corner. This is the support frame. Drill the end of the boards frame and the support frame for making pilot holes for wooden screws. Drill two holes 2 inches apart and 2 inches from each corner. Fit the holes in the support frame with those in the posts and insert thread screws through the frame and into the posts;

READ ALSO :   Modern Three Bedroom House Plans

Loft bed plans with stairs will be on the inside of the posts. Get someone to hold the frame up or support bricks to keep it at the level required until the bolts are inserted. Tighten the screws. Measure 54 inches from the bottom of 4-times-4 posts and makes a line on each 4-of-4; it will be on the inside of the posts above the support frame. Measure 2 inches and make a point 2 inches from the edge; measure up another 2 inches and make a point. Drill every 4 of 4 posts on these points. Position the bed frame between the posts and lift it up until the holes in the frame are aligned with those in the posts. Put delay bolts in the holes and finger tighten the screws.

READ ALSO :   Garage Folding Workbench

 

Share.

Comments are closed.