**Woodpecker router table** for your garage will maximize your work space and will give you your own place to keep tools and work with projects. If you are already a do-it-yourself enthusiast or if you are a prospective one, it’s only appropriate to build your own workbench. A garage workbench does not have to be a big shiny structure beauty. All it has to do is support your function, and everyone can achieve this with the right guidance

## Instructions

Stand your four 4-times-4 pieces of wood up to use them as legs for your woodpecker router table review. Measure 15 inches from the bottom with a tape measure and mark this with a pen on all four sides of each leg. Nail a 30-inch 2-times-4 piece of wood on one side of 4-times-4 on pencil marking, with two nails and a hammer. Place 30-inch 2-times-4 with 4-inch measurement upwards before nailing it. Repeat this step for every 4-times-4. Rough up an unused 30-inch 2-times-4, with 4-inch upward measurement, with the top one unused 4-times-4 so that they even then spice them together with two nails and hammer. Repeat remaining unused 4-times-4 and 30-inch 2-times-4.

Take a bite from step 2 along with a bit from step 3 so that 2-4 times from each bit comes into contact with the other 4-times-4. Nail them together with two nails for each 2-times-4 to create a woodpecker router table stand with two legs. Repeat this with the remaining bits from steps 2 and 3. Place the pieces from step 4 so that each part has a front leg and a hind leg. Use two nails per side to connect an 88-inch 2-times-4, with 4-inch upward measurement, on the inside of each rear leg of the 15-inch brand. Repeat this with the front legs. You should have a symmetrical frame.

Nail an 88-inch 2-times-4 to connect the tops of the two hind legs so that the top of 4-by-4 and the top of 2-times-4 is still. Use two nails per page. Repeat this for the front legs. Make sure 4-inch measurement of 2-times-4 is facing upwards. Pay extra attention to the position of the nails so that they do not hit the other nails in 30-inch 2-by-4s to connect the front and back legs. Put the 38-of -96-inch plywood on top of your structure so that the corners are perfectly lined with the top of each leg. Spike plywood on the legs, with two nails per side. Carefully place your nails so that you do not meet the other nails from previous steps.