How to Making Gun Display Case


Gun display case is an ideal place to store a gun, if it has foam cover and lock for the gun. Is easy and perfect for those who may not have the means to buy a real gun case make a wooden storage box for a gun.


Use a pen and tape measure to draw four pieces on the plywood. Two of the retail gun display case should measure 8 inches in length and 2 1/2 inches in height. The remaining two pieces should measure 12 inches in length and 2 1/2 inches in height. Cut each of the pieces using a saw and sandpaper edges smooth. Cut two more pieces as each action 12 inches in length and 9 inches in height. Sandpaper edges. Color or bets each bit as desired. If any additional construction needs to be redesigned, do it now. Allow the pieces to dry before proceeding. It may take up to 24 hours if the color is added in several layers.

READ ALSO :   Dongardner Com

Place the front piece measuring 12 inches in length and 2 1/2 inches in height on its side so that it stands up. Rough up one of the 8-inch long pieces so the 2 1/2 inch sidelines up with the original play. The horizontal gun display case should be perpendicular to each other and 8-inch bits should be on top of the original piece, create an L shape. Attach one of the side edges to the front of the case by erasing the identical cut sides. Attach nails to the inside of the front piece, as it is a half inch longer to fit the 3/4 inch thick plywood. Do the same for the other side post. Raise the back piece and nail it on the side pieces. Make two markings on 12-inch pieces where the crossing is and hammer two nails in the play to connect two.

READ ALSO :   How You Can Create Beautiful Bunk Bed Plans

Repeat this step for the opposite end of 12-inch bit with the other 8-inch bit. Again, the 8-inch bit should be on top of the 12-inch piece and should be perpendicular to this. Use the hammer and nail to attach the play. The final form should look like a U. Fit the other 12-inch long piece so that it overlaps both ends of 8-inch pieces. Connect pieces at both ends by hammering nails into 8-inch pieces through 12-inch pieces. A rectangular frame has now been created. Raise one of the 12-inch with 9-inch pieces so that it sets up with each side of the rectangle. Use nails to connect it to the frame by hammering nails along the circumference. In this way the lower part of the case is connected.

READ ALSO :   Keel Construction Out Of Plywood

Comments are closed.